This section assumes you have Linux and KVM experience. The following procedure creates leaf01, leaf02, and spine01 and the network connections between them. These steps were tested with Cumulus VX 4.2, KVM/QEMU version 1:4.2-3ubuntu6.3, and Libvirt version 6.0.0 on Ubuntu Linux version 20.04. Create three VMs (leaf01, leaf02, and spine01) and the network connections between them.To facilitate additional configuration after the initial setup descibed in this guide, leaf01 and leaf02 also have two connections to each other. ![]() leaf01 and leaf02 connect to spine01, which is the aggregation layer switch on the network. In the topology, leaf01 and leaf02 are the access layer switches on the network. This section describes how to install and set up Cumulus VX with KVM/QEMU and Libvirt on a Linux server to create the two leaf and one spine topology shown below. It uses XML to represent and define the VM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |